数控钢筋笼滚焊机每天开机之前，要对机子进行的检查，主要检查的内容如下：

Before starting up the CNC steel cage rolling welding machine every day, a comprehensive inspection should be conducted on the machine. The main inspection contents are as follows:

（1）要检查急停按钮（三个中的任意一个）是否处于按下状态C控制电源开关是否处于关闭状态；

(1) Check whether the emergency stop button (any one of the three) is in the pressed state, and whether the control power switch is in the off state;

（2）各条线路连接是否为正常状态；

(2) Whether the connections of each line are in a normal state;

（3）要仔细检查是否存在漏油情况；

(3) Carefully check for oil leakage;

（4）各螺栓螺帽有无松动情况；

(4) Check for any looseness in the bolts and nuts;

（5）电气柜内粉尘是否过多。

(5) Is there too much dust inside the electrical cabinet.

数控钢筋笼滚焊机在运行过程中，要注意检查马达是否有过热现象。

During the operation of the CNC steel cage rolling welding machine, attention should be paid to checking whether the motor is overheated.

数控钢筋笼滚焊机运行过程中，严禁对电气部分进行遮盖，要保持散热顺畅。

During the operation of the CNC steel cage rolling welding machine, it is strictly prohibited to cover the electrical parts and ensure smooth heat dissipation.

设备运行2个月左右后，要对断路器马达接线端子电箱内接线端子，在电源切断的情况下进行重新紧固。

After about 2 months of operation, the circuit breaker motor wiring terminals inside the electrical box should be re tightened with the power cut off.

2个月左右要对减速机液压站油量进行定期检查。若不足，需要进行添加，如有漏油现象要进行及时进行修理。

Regular inspection of the oil level at the hydraulic station of the reducer should be carried out around 2 months. If it is insufficient, it needs to be added. If there is any oil leakage, it should be repaired in a timely manner.

每个星期要对所有的润滑油嘴进行打黄油一次。

Apply butter to all lubrication fittings once a week.

设备正常运行2个月左右，要对所有的螺栓螺帽进行重新紧固。

The equipment has been running normally for about 2 months, and all bolts and nuts need to be re tightened.

每周要定期用油漆毛刷或微风吹风机电气柜中的灰尘，保持电气柜内清洁，否则可能会引起短路烧坏设备的事故发生。

Regularly clean the dust in the electrical cabinet with a paint brush or a breeze blower every week, and keep the cabinet clean. Otherwise, it may cause accidents such as short circuits and equipment damage.

对配套设备，如液压站的维护保养请参阅相应产品使用说明书（严防进水拆卸相应零部件严防灰尘和其他脏物进入）。

For the maintenance and upkeep of supporting equipment, such as hydraulic stations, please refer to the corresponding product user manual (strictly prevent water ingress, disassembly of corresponding components, and entry of dust and other dirt).