焊接机操作规程(焊机维修规程)启动后，应先空运转，检查各传动部件及轴承运转正常后，方可操作。
Welding Machine Safety Operating Procedures (welding machine maintenance procedures) start, should first air operation, inspection of the transmission parts and normal operation of bearings, before the operation.

山东焊接专机共5步操作流程掌握吗？
Shandong welding machine total 5 Steps Operation Process Control?

1.起动前，必须检查切刀是否有裂纹，刀架螺栓紧固，防护罩牢固.再用手转动轮齿，检查齿轮啮合间隙，调整刀片间隙.
1. Before starting, must check whether the cutter has cracks, knife frame bolt fastening, shield firm. Turn the gear tooth by hand, check the meshing clearance of the gear and adjust the blade clearance.

2、当机器没有达到正常转速时，山东焊接专机不能切割，必须使用切割刀的中下位置，握持钢筋对着刀口快速送进，操作者应站在固定刀片的一侧用力压住钢筋，防止钢筋末端弹出伤人.严禁用两手在刀片上夹住钢筋。
 2, when the machine does not reach the normal speed, can not cut, must use the cutting knife in the lower position, holding the steel bar to the edge of the knife, the operator should stand on the side of the fixed blade to press the steel bar, prevent the end of the steel bar from popping out and hurting people. It is strictly forbidden to clamp the rebar on the blade with both hands.

3.起动后，应先空运转，检查各传动部件和轴承运转正常后方可使用。
3. After starting, should first air running, check the transmission parts and bearings running properly before use. 

4.不得剪切直径和强度超过机械铭牌规定的钢筋和烧红的钢筋.当一次切断多根钢筋时，其总截断面积应在规定范围内。
4. Shall Not Shear diameter and strength over the mechanical nameplate provisions of the reinforcement and red-hot reinforcement. When cutting several reinforcing bars at one time, the total cut-off area should be within the prescribed range. 

5.送料的工作台面应和刀片下部保持水平，山东焊接专机工作台长度可根据加工材料长度确定，加工较长的钢筋时，应专人协助，听从操作人员指挥，不得任意推拉。
5. Feed table should be level with the lower part of the blade, table length can be determined according to the length of processing materials. When processing longer steel bar, should be specialized assistance, follow the operator’s command, not arbitrary push and pull.