焊接操作机在焊接技术人员工作中使用比较遍及,但是在使用焊接操作机时应留意什么呢？山东数控焊接设备小编总结了一些内容点给大家作为参考信息使用，如下：

Welding operators are widely used in the work of welding technicians, but what should be paid attention to when using welding operators? Shandong NC welding equipment editor summarized some content points for reference, as follows:

焊接前工作人员要,检查对焊接操作设备的压力组织应灵敏,检查焊机设备和工具是否，夹具应牢固,气、液压体系无泄漏,焊接电缆绝缘外套有无破损，确认正常后,方可施焊.(在设备上进行焊接前，应先把设备的接地或接零线拆掉，焊接完后再恢复。)

Before welding, the staff shall check whether the pressure organization of the welding operation equipment is sensitive, whether the welding equipment and tools are safe, whether the clamps are firm, whether the gas and hydraulic systems are free of leakage, and whether the insulating jacket of the welding cable is damaged. Welding can be carried out only after it is confirmed to be normal (Before welding on the equipment, the grounding or neutral line of the equipment shall be removed first and then restored after welding.)

进行电焊作业前，应检查作业环境，危险有害因素和设置监护人员。当附近有其他人员和有关设施时，应采用屏护和间隔等，保证作业。需在高处焊接作业时，一定要挂好带。

Before electric welding operation, the operating environment shall be checked, hazardous and harmful factors shall be removed, and supervisors shall be arranged. When there are other personnel and relevant facilities nearby, shielding and spacing shall be adopted to ensure the safety of operation. When welding at heights is required, safety belts must be hung.

对焊接操作机应安顿室内,并有牢靠的接地.如多台对焊接操作机并列安装时,间距不得少于3m.

Butt welding operators shall be installed indoors and firmly grounded. If multiple butt welding operators are installed in parallel, the spacing shall not be less than 3m

改变焊机接头，更换焊件需要改接二次回路时，应选择转移工作地点、焊机检修暂停工作或下班等，且一定要切断电源后方可进行操作。

When the welding machine joint is changed and the secondary circuit needs to be connected when the welding parts are changed, the work place should be transferred, the welding machine maintenance should be suspended or off duty, and the power must be cut off before operation.

焊机应设置在防雨和通风良好的地方。焊接现场不准堆放易燃易爆物品。

The welding machine shall be set in a rain proof and well ventilated place. Inflammables and explosives are not allowed to be stacked on the welding site.

以上就是给大家介绍的自动焊接设备在操作前后分别需要注意的事项，大家也要记住一点，在更换焊条时，焊工应戴绝缘手套，防止出现不必要的事故。希望以上内容能帮到大家，关注我们网站http://www.tayfsk.com了解更多！

The above are the precautions for automatic welding equipment before and after operation. You should also remember that welders should wear insulating gloves when changing welding rods to prevent unnecessary accidents. I hope the above content can help you to follow our website http://www.tayfsk.com Learn more!