今天山东焊接专机小编来跟大家聊聊焊接专机焊接机操作过程中有哪些需要注意的事项，希望对大家能有所帮助。

Today, the small editor of Shandong Welding Machine came to talk with you about what should be paid attention to during the operation of the welding machine of the welding machine. I hope it can help you.

1.设备主机及焊接头外观注意防尘。

1. Pay attention to dust-proof appearance of equipment host and welding joint.

2.水机两侧勿堆放杂物并保持1米空间以保证通风制冷。

2. Do not stack sundries on both sides of the water machine and keep a space of 1m to ensure ventilation and refrigeration.

3.每日早班时先检查焊接头保护镜片，再开机开气。

3. Check the protective lens of the welding head at the morning shift every day, and then turn on the machine to open the air.

(检察时保护镜抽屉拉出一半能看到镜片中间位置即可)

(During inspection, pull out the protective mirror drawer half to see the middle of the lens)

4.焊接过程中若出现能量减弱现像，应立即停机并检查保护镜片，检查方法同上。如有黑色烧点及时更换。

4. In case of energy loss during welding, stop the machine immediately and check the protective lens. The inspection method is the same as above. If there are black burning spots, replace them in time.

5.更换保护镜片时注意事项

5. Precautions when replacing protective lenses

①先关闭焊接头附近所有吹气，吹风设备。减少空气流动。

① First, close all air blowing and air blowing equipment near the welding head. Reduce air flow.

②用无尘布蘸酒精或丙酮将保护镜抽屉周边擦拭干净。

② Wipe the perimeter of the protective mirror drawer with a dust-free cloth dipped in alcohol or acetone.

③取下保护镜抽屉后，应立即用美纹纸将保护镜抽屉窗口封住，防止灰尘进入焊接头内。

③ After the protective mirror drawer is removed, the window of the protective mirror drawer shall be immediately sealed with masking paper to prevent dust from entering the welding joint.

④更换保护镜片时，不能接触镜片表面应捏住镜片侧边。

④ When replacing the protective lens, the side of the lens should be pinched if the lens surface cannot be contacted.

⑤换好镜片后，用吹气球吹去表面浮尘。

⑤ After changing the lens, blow the floating dust off the surface with a blowing balloon.

⑥取下封口美纹纸，按正确方向将保护镜抽屉装回。

⑥ Remove the sealing paper and replace the protective mirror drawer in the correct direction.

6、焊接应尽量减少焊接烟尘，若烟尘过多，需配备抽尘没备将烟尘抽走。

6. Welding fume shall be reduced as much as possible. If there is too much fume, it is necessary to provide dust extraction to remove the fume.

为了保障您的人身以及延长设备的使用寿命，请熟知以上操作，如有问题请联系我们http://www.tayfsk.com咨询！

In order to ensure your personal safety and prolong the service life of the equipment, please be familiar with the above safe operations. If you have any questions, please contact us http://www.tayfsk.com consulting service