1.焊枪电缆不要压得太紧，弯曲角度也不能太小。送丝软管的半径不应小于150mm，否则内部电缆会损坏，可能导致事故。焊接期间请勿更改电压调试开关。

1. The welding gun cable should not be pressed too tightly, and the bending angle should not be too small. The radius of the wire feeding hose should not be less than 150mm, otherwise the internal cable may be damaged and may cause accidents. Do not change the voltage adjustment switch during welding.

2.在焊接操作过程中，请勿触摸带电部件，例如焊接机的输出接口。

During welding operations, do not touch live parts, such as the output interface of the welding machine.

3.更改或调试面板旋钮时，请勿过分用力。自动不锈钢管焊接机可能会损坏设备。

3. When changing or debugging the panel knobs, do not apply excessive force. The automatic stainless steel pipe welding machine may damage the equipment.

4.每次焊接之前，请检查焊接机的连接是否正确以及接地线是否可靠。

Before each welding, please check whether the connection of the welding machine is correct and whether the grounding wire is reliable.

全自动焊接设备检查：操作员在每次焊接操作前要检查以下项目：

Safety inspection of fully automatic welding equipment: Operators should check the following items before each welding operation:

1.确保焊接机相互良好的接地是可靠的安装。

1. Ensure that the welding machines are reliably installed with good grounding.

2.确保焊接机的输入和输出电缆完好无损。

2. Ensure that the input and output cables of the welding machine are intact and undamaged.

3.安装并固定了焊接机后，人员要定期对其进行检查。

After installing and fixing the welding machine, professional personnel should regularly inspect it.

4.不会有内部间隙等异常情况。检查并确认送丝辊的凹槽和齿型完好无损，并且在磨损或接触不良时应更换辊和接触头块。

4. There will be no abnormal situations such as internal gaps. Check and confirm that the grooves and teeth of the wire feeding roller are intact and undamaged, and replace the roller and contact head block in case of wear or poor contact.

更多的关于山东焊接专机问题或者详细的内容，请进入我们公司的网站：http://www.tayfsk.com网站中会有很多的内容仅供参考

For more information or detailed information about Shandong welding machines, please visit our company's website: http://www.tayfsk.com There will be a lot of content on the website for reference only